Leer 1LG0300000 Manual Para Usuarios página 6

COVER ATTACHMENT
1. To attach the travel cover, slide the rounded fabric end of
the cover into the rounded C-channel at the hinge side of
the tent base. Make sure the cover is oriented so the exterior
side of the cover faces up when you pull the cover over
the tent.
2. Fasten the velcro straps on either side of the tent to hold the
canopy in place.
3. Zip the travel cover to the base along the other three edges,
taking care that the tent fabric does not become caught in
the zipper.
4. Secure the two long velcro straps over the top of the
travel cover.
6
ATTACHMENT TO ROOF RACK
1. Place the tent on top of your vehicle rack system, ensuring
the mounting tracks are perpendicular to the bars they will
mount to, and the tent is centered on the roof rack. Position
the hinge so that the tent will open to the desired side.
2. Slide the 13mm bolts and channel sliders into the mounting
tracks. Lift one side of the tent to position one set of bolts
and channel sliders on the inner side of the roof rack bar and
an additional set on the opposite side. Repeat on all four
corners.
3. At each of the four corners where the rack bars and mounting
tracks cross, using a steel mounting plate and nylock nuts to
secure the bolts on either side of the bar. Tighten all eight
bolts securely with the included nuts and wrench. Check all
the mounting bolts and brackets periodically during use to
ensure they are securely fastened to your rack system.
4. After ensuring the tent is positioned correctly and all eight
bolts are tightened securely, insert rubber end caps into the
ends of the mounting tracks. This may require light taps from
a hammer.