Bosch ROS10 Instrucciones De Funcionamiento página 10

2610051955.qxp_ROS10 ROS20VS 8/16/18 1:58 PM Page 10
CLEANING AND EMPTYING THE
DUST CANISTER
Before opening the dust canister lid, it is
recommended to loosen dust from the
microfilter dust canister by gently striking it
against a solid surface (Fig. 8).
To empty canister, hold canister and maintain
a firm grip. Firmly push upward on tab on
corner of lid, and remove from canister (Fig. 9).
Knock excess dust out of the microfilter, or
remove dust with your fingers or a soft brush.
You may notice that all the dust may not come
out of the canister. This will not affect sanding
performance but will reduce dust collection
efficiency.
NOTE: Do not wash the micro filter with soap
and water. Dust may become more firmly
lodged in the pores, which will reduce dust
collection, and damage the micro filter.
FIG. 8
FIG. 10
Dust collection can also be achieved by
attaching the tool to a vacuum cleaner / dust
extractor, hose and adapter, if necessary (all
sold separately).
1. Attach the hose to the vacuum cleaner /
2. Attach the hose to the tool's dust port in one
- Bosch VH-series hoses - The VX120 hose
- Other 35mm and 22mm hoses, such as the
- Common 1-1/4" or 1-1/2" hoses - The
C4
DUST CANISTER LID
BOSCH VAC-
SERIES HOSE
VAC002
DUST
PORT
-10-
ATTACHING A VACUUM CLEANER
dust extractor.
of the following ways (Fig. 10):
adapter is required (included with VH-series
hoses).
Bosch VAC-series hoses - Connect hose
directly to the tool.
Bosch VAC002 or VAC024 adapter is
required.
MICROFILTER
BOSCH VH-
SERIES HOSE
VX120
VAC024
FIG. 9
1-1/4"
OR
1-1/2" HOSE