Dash Disassembly - Metra 99-6517HG Instrucciones De Instalación

1. Remove (1) plastic push-pin
fastener from the right edge facing
up on the panel above the radio and
instrument cluster. (Figure A)
2. Unclip and remove the entire panel.
(Figure A)
3. Unclip and remove the end panel
on the driver's side of the dash.
(Figure B)
4. Remove (1) Phillips screw on the
edge of the knee bolster panel then
unclip the panel and let it hang.
Note: You do not have to fully
remove this panel. (Figure C)

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
®
99-6517HG
5. Remove the screws securing
the steering column gap cover
into place, unsnap the top of the
column trim and pull it back over
the wheel far enough to remove
the instrument/radio panel.
(Figure D)
6. To remove the instrument/radio
panel, remove eight screws across
the top and one from the bottom
left side. (Figure E, F)
7. Remove the radio mounting screws
and remove the factory radio.
Continued on next page
2
(Figure D)
(Figure E)
(Figure F)