Usb Operation - Numark M1USB Manual De Inicio Rápido

USB OPERATION

The M1USB is equipped with two USB ports which allow you to play content from your computer through the mixer, or
record audio from the mixer directly into your favorite software application. The USB interface on your mixer works
with your computer just like a standard USB sound card. In addition, the USB interface is class-compliant, so there
are no special drivers or software to install; simply connect a USB cable from either or both USB ports to your
computer and you are ready to go!
WINDOWS CONFIGURATION
1. Turn on your computer and the M1USB.
2. Use a USB cable to connect one (or both) ports of the M1USB to your computer.
3. Windows will immediately recognize the mixer as a "USB Audio Device" or "USB Audio CODEC" and will
automatically install any required system components.
To change system audio preferences in Windows, you will need to
access the Sounds and Audio Devices properties, located in the
Control Panel. To access audio device settings, click on the
Audio tab.
The first time you connect the M1USB to your computer, the mixer
will be automatically assigned as the Default (or "Preferred")
Device for sound playback on your computer.
computer's sounds will be sent to the mixer channel indicated
above the USB connection.
Note: If you have connected both USB ports to your computer, the
ports will be numbered in the order they were connected. For
example, if you connected USB A before USB B, USB A will
appear as "USB Audio CODEC" and USB B will appear as "USB
Audio CODEC (2)".
To send audio from your computer into the M1USB, select
"USB Audio CODEC" in the Sound Playback field. This
allows you to play audio from your computer into one of
either of the mixer channels, depending on which USB port
is used to make the connection.
To send audio from the M1USB to your computer, select
"USB Audio CODEC" in the Sound Recording field. This
allows you to record your mix into your computer.
Note: If your sound playback or recording application does not have its own audio input and output settings (for
example, Windows Sound Recorder, Windows Media Player or Apple iTunes), it will use the devices set in Sounds
and Audio Devices. Please note that these settings are loaded upon application startup, so if you change device
settings while the application is open, you will need to restart your application for the settings to take effect.
Tip: To prevent Windows from playing system sounds (beeps and bleeps) through the M1USB, we highly recommend
disabling these by clicking on the Sounds tab and selecting No Sounds from the pull-down menu.
All of your
6