DeWalt DW152 Manual De Instrucciones página 20

E N G L I S H
Follow the instructions for maintenance and
changing accessories. Inspect the tool cords at
regular intervals and, if damaged, have them
repaired by an authorized D
Inspect the extension cords periodically and
replace them if damaged. Keep all controls dry,
clean and free from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for
damage to ensure that it will operate properly
and perform its intended function. Check for
misalignment and seizure of moving parts,
breakage of parts and any other conditions that
may affect its operation. Have damaged guards
or other defective parts repaired or replaced as
instructed. Do not use the tool if the switch is
defective. Have the switch replaced by an
authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Package contents
The package contains:
1 Heavy duty drill
2 Side handles
1 Breast plate (with fixing bolt)
1 Drift wedge
4 Hexagonal screws
1 Mixing adaptor (DW152)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your D WALT heavy duty drill has been designed for
E
professional applications:
D WALT DW152 drill - heavy duty mixing, thread
E
tapping and drilling.
D WALT DW153 drill - heavy duty thread tapping
E
and drilling.
en - 3
WALT repair agent.
E
The tool can be mounted on a drill stand for use as
a stationary tool.
1 ON/OFF-switch
2 Lock-on button
3 Forward/reverse-switch
4 Two gear selector
5 Carrying handle
6 Threaded side handle
(also serving as drift wedge holder)
7 Control side handle
(with additional ON/OFF-switch [1])
8 Tool holder
9 Drift wedge
10 Drift wedge slot
11 Gear housing
12 Breast plate
13 Carbon brush access cover
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
15