Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500 W,
we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
2
. When using a cable reel, always
unwind the cable completely.
Also refer to the table below.
Conductor size (mm
2
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
16
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
Assembly and adjustment
Inserting and removing an accessory (fig. A)
This tool uses morse taper type accessories.
• Insert the tapered shank into the tool holder (8).
The accessory will be automatically locked in
position.
• To remove the accessory insert the drift wedge (9)
into the drift wedge slot (10) and strike it with a
.
hammer. The drift wedge can be stored in the
hollow housing of the threaded side handle (6).
Fitting the side handles (fig. B)
The tool is equipped with two removable side
handles (6 & 7) to operate the drill when it is used as
a hand-held tool.
Threaded side handle
• Screw the handle (6) into position and tighten it.
Control side handle
• Mount the handle (7) onto the gear housing (11)
using the four hexagonal screws (14) provided.
Mounting the breast plate (fig. B)
The breast plate (12) enables optimal control of the
drill when it is used as a hand-held tool.
• Mount the breast plate (12) to the rear end of the
tool using the fixing bolt (15) provided.
60
6
10
15
20
25
Forward/reverse-switch (fig. A)
-
The forward/reverse action in both gears enables the
-
-
tool to be used for e.g. thread tapping.
6
6
• To select forward or reverse rotation use the
6
6
forward/reverse-switch (3).
15
R (Right) : forward rotation
15
L (Left)
20
-
Prior to assembly and adjustment always
unplug the tool.
When using the drill as a hand-held tool
always make sure that the side handles
and breast plate are properly assembled.
: reverse rotation
E N G L I S H
en - 4
Publicidad
Tabla de contenido
