DeWalt DW152 Manual De Instrucciones página 22

E N G L I S H
The direction of rotation must only be
changed when the motor has come to a
complete standstill. A safety device
prevents any change of rotation if the
motor is still switched ON.
Two gear selector (fig. C)
The tool is fitted with a two gear selector (4) to vary
the speed/torque ratio.
• Release the ON/OFF-switch and select the
required position after the motor has come to a
complete standstill.
I low speed/high torque
(drilling large holes) (position I)
II high speed/low torque
(drilling smaller holes) (position II)
For speed rates, refer to the technical data.
Do not try to change gears at full speed
or under load.
Mounting the drill onto a drill stand (fig. D)
Your drill can be mounted on a drill stand (optional)
for stationary use.
• Remove the breast plate by loosening the fixing
bolt.
• Remove both side handles.
• Mount the tool onto the drill stand. Make sure to
tighten all fixing bolts provided with the drill stand.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Apply only a gentle pressure to the tool.
Excessive force decreases tool
performance and may shorten tool life.
Using the drill as a hand-held tool (fig. A)
• Fit the side handles and the breast plate.
• Insert the appropriate accessory.
• Select the direction of rotation.
• Select the appropriate speed/torque ratio.
• To run the tool, press the ON/OFF-switch (1) in
the control side handle (7).
• To stop the tool, release the ON/OFF-switch.
Always switch OFF the tool when work is finished
and before unplugging.
en - 5
Stationary use (fig. A)
• Remove the side handles and the breast plate.
• Mount the tool onto a drill stand (shown in fig. D).
• Insert the appropriate accessory.
• Select the direction of rotation.
• Select the appropriate speed/torque ratio.
• To run the tool, press the ON/OFF-switch (1) in
the carrying handle (5).
• If necessary, press the lock-on button (2) for
continuous operation and release the ON/OFF-
switch. The lock-on button works both in forward
and reverse rotation.
• To stop the tool, release the ON/OFF-switch.
• To stop the tool in continuous operation, press the
ON/OFF-switch briefly.Always switch OFF the tool
when work is finished and before unplugging.
Mixing
• For mixing, fit an appropriate mixing accessory.
Do not mix or stir inflammable liquids
labelled accordingly.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
• The heavy duty drill is not user-serviceable.
We recommend to take the tool to a D
authorized repair agent after approximately
150 hours of use.
Lubrication
Your Power Tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
WALT
E
17