Fitting Cover; Attaching Connecting Cable 1 684 463 - Bosch 1 687 010 393 Manual Original

en 20 | 1 687 010 393 |
3.4.5

Fitting cover

1. Push the connecting cables (fig. 9, item 3 and 4)
through the openings in the cover (fig. 9, item 1).
2. Push the cable bushings (fig. 9, item 5) of the two
connecting cables (fig. 9, item 3 and 4) through the
openings in the cover.
3. Secure the connecting cable (fig. 9, item 7) to the
cover.
4. Push the connecting cable (fig. 9, item 8) into the
recess (fig. 9, item 6).
5. Fit the cover.
6. Fix the edge protection (fig. 9, item 2) over the met-
al edge of the recess (fig. 9, item 9).
3 4
2
1
8
458885-06_Pal
Fig. 9: Fitting cover
7. Secure the side of the cover (fig. 9, item 1) to the
side frame with four countersunk bolts.
|
1 689 989 187 2016-12-20
5
6
7
9
3.4.6 Attaching connecting cable 1 684 463 931
¶
Insert connecting cable 1 684 463 931 into connec-
tion X6 of the printed circuit board A2.
X 6
Fig. 10:

Attaching connecting cable 1 684 463 931

Robert Bosch GmbH