Technical Specifications; Safety Instructions; Instructions For Power Safety - Menzer ESM 406 Manual Original

MENZER ESM 406
SINGLE-DISC SANDER
Original instructions
Milý zákazníku,
Dear customer,
By purchasing the MENZER ESM 406 Single-disc Sander you have selected a product of the highest quality.
We would hereby like to express our gratitude for the trust you have shown in us and our tools.
tions on the following pages. Close observance of the information contained here will ensure an optimum
result for your work. The safety warnings are intended to protect you from accidents that could be caused
by improper use of the single-disc sander.
The MENZER Team
SEZNAM TABLE OF CONTENTS
the storage and application instructions which are described here. The user who operates this machine
1. does so at his or her own risk and assumes full responsibility for that operation. These instructions should 1. TECHNICKÉ ÚDAJE

TECHNICAL SPECIFICATIONS

be kept and used for future reference.
2.

SAFETY INSTRUCTIONS

2.1 2.1

Instructions for power safety

Elektrické zapojení
1. TECHNICAL SPECIFICATIONS
2.2 Safety in your working environment
2.3 Operating safety tips
Model: MENZER ESM 406
3. Voltage: OPERATING THE MACHINE 230 V ~ 50 Hz / 110 V ~ 50 Hz
3.1 Starting off
Speed under load: 3.2 3.2 Operating the machine Pracovní provoz approx. 150 min
Driving disc: 3.2.1 Use as a sanding machine Ø 406 mm
Machine weight: 3.2.2 Use as a cleaning tool 32 kg
3.2.3 Safety instructions for cleaning tasks
4. STORAGE
SANDING SET: 5. MAINTENANCE
- 5.1 1 x drive assembly Care and maintenance
5.2 1 x push rod & handle bar assembly Troubleshooting
6. MACHINE DETAILS
1 x 12.5-kg additional weight
7. CE DECLARATION
CLEANING SET:
8. 1 x drive assembly TERMS OF GUARANTEE
1 x push rod & handle bar assembly
1 x water tank
2. SAFETY INSTRUCTIONS
Be sure to wear ear protection if the noise level exceeds 85 dBA!
2.1 INSTRUCTIONS FOR POWER SAFETY
This machine may be connected ONLY to sockets that provide the operating voltage displayed on the
ensure that a driving disc for sanding or polishing discs is attached.
Do not leave the machine standing unattended if it is connected to a power supply. Disconnect the
Inspect the power connector cable regularly for damage. Do not use the machine if the power cable or
plug is damaged.
Version 1.3 Verze 1.3
CZ 3 EN 3
EN 3
CZ 3 EN 3
EN 4
EN 4
EN 5
EN 5
EN 5 CZ 5
-1
EN 5
EN 6
EN 7
EN 7
EN 8
EN 8
EN 8
EN 10
EN 12
EN 13
-
-
EN 3