Symbols; Preparation; Using The Product Via The Control Unit - Imetec N1701 Instrucciones Para El Uso

Protection class II
Warning
Prohibited
Temperature selector
®
Bluetooth
PLACING THE ELECTRIC BLANKET FIG. (A-B)
IMPORTANT!
The electric blanket must only be placed between the mattress and the first sheet and not on top of
persons in bed.
• Spread the electric blanket on the mattress with the side where the plug (6) is connected facing the mattress.
• Make sure the electric blanket is always laid out properly.
• Place the flat sheet over the electric blanket and then make the bed as usual with sheets and covers.

USING THE PRODUCT VIA THE CONTROL UNIT

CONNECTING AND REMOVING THE TEMPERATURE ADJUSTMENT CONTROL FIG. (B)
IMPORTANT!
The electric blanket must only be used with the control unit supplied. The relative model is specified
on the label sewn onto the product.
• Insert the plug (7) in the socket (6) to connect the temperature control to the electric blanket.
• The same must be done with the second plug in the double bed model.
• Disconnect the plug (7) from the electric blanket by pressing the pushbuttons at the sides of the plug (6).
SWITCHING THE ELECTRIC BLANKET ON AND SELECTING THE CORRECT TEMPERATURE FIG. (C)
IMPORTANT!
DO NOT place the control unit under the pillow or under the sheets when in use.
• Turn the electric blanket on from the rear of the control unit, placing the switch to ON (I) (14) (Fig. [C]).
• FAST HEAT – the INTELLISENSE technology automatically sets the temperature to fast heat 6.
temperature 6 while in bed.
• If the electric blanket is in standby, press the temperature button (12) to turn on the fast heat function until number 6 lights up
in red on the temperature display (10) (Fig. [C]).
• For use at night or continuous use, select the desired temperature setting between 1 and 5 by pressing the temperature button
(12) (Fig. [C]) until the desired temperature lights up in orange on the temperature display (5).
MEMORY FUNCTION
After a few minutes of use, the electric blanket will save the last temperature selected.
AUTO SHUT-OFF FUNCTION
The electric blanket has an automatic shut-off system. You can set the time between 1 hour or 9 hours.
• TIMER – press the timer selector
activation signal
®

PREPARATION

(11) (Fig. [D]) until 1 hour or 9 hours light up in green (9).

SYMBOLS

Timer selector
Standby
Off position
On position
EN
DO NOT use FAST HEAT
9