Troubleshooting - Bohmer-AG AG-178-FD Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

AG-178FD / AG-192FD

Troubleshooting

ignition sources. The product is NOT supplied with engine oil, although traces of oil from the manufacturing process may be present. It is essential
to add adequate engine oil of the correct type to the engine before use – see Checking and Changing Engine Oil.
Failure to add engine oil will void the product warranty.
required. • The engine should be cool enough to touch before performing maintenance activities. • Some maintenance activities described may
be beyond the scope of some users. For procedures that you are not comfortable with or have the tools or experience for, or if problems persist
after following all suggested actions, contact a service centre or qualified technician.
The following information may assist in identifying a problem and rectifying it
Difficulty Starting the Engine
Possible Fault
Lack of fuel
Engine 'OFF'
Engine 'Flooded' with fuel
Not enough or too much engine oil Check oil level and ensure that the level is at or just below the recommended maximum level.
Engine Starts but does not Idle
Possible Fault
Blocked Air Filter
Idle speed requires adjustment
Running combustion engines in confined areas CAN KILL IN MINUTES. Engine exhaust fumes contain carbon-
monoxide – a deadly gas that you cannot smell or see. NEVER run a combustion engine in confined areas
EVEN IF windows and doors are open. ONLY run combustion engines OUTDOORS and away from doors,
windows and vents. • Petrol/fuel/gasoline is extremely flammable – keep clear of naked flames or other
• Do not have the engine running during inspection and maintenance unless specifically
Check that there is fuel in the tank and the fuel tap is in the "ON" position. • To further check if fuel is
reaching the carburettor, remove the carburettor drain plug and check if fuel drains.
Ensure engine ON/OFF switch is in the "ON" position.
Place the choke in "HOT" or "RUN" position. Leave the ON/OFF switch in the "OFF" position. Pull the starter
cord several times to assist clearing excess fuel from engine before attempting to start engine.
Check and clean the Air Filter
Adjust the idle speed until the engine runs smoothly and at a reasonable speed when idling
© Böhmer-AG 2020
Action
Action
17

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ag-192-fd

Tabla de contenido