Assembly; Electric Start - Bohmer-AG AG-178-FD Manual De Instrucciones

AG-178FD / AG-192FD

Assembly

Typically, most engines are fully assembled, however, some models may
require the following assembly (as applicable). The image below shows
an unassembled electric start model with exhaust shroud.
Exhaust Shroud
Place the shroud (A) over the exhaust port – generally with the opening
facing down, and attach it using the 4 supplied screws.

Electric Start

If the electric start switch block has been supplied unassembled, it will require attachment to the engine and the wiring connected. Attach the
switch block (B) to the brackets on the engine using the 2 supplied bolts. The mounting brackets on the engine may vary slightly between models,
however, the switch block is always located next to the starter motor. Connect wires as follows:
No. Wire Colour
01 Green
02 Red
03 White
No. On Engine
04 Push Terminal
05 Blue Wire
06 Earth Terminal
06
Use
Ignition
Starter Motor Power
Starter Motor Earth
Use
Connect to '3'
Connect to '1'
Connect to '2'
© Böhmer-AG 2020
04
06
01 02 03
A
05