EAS ELECTRIC E300WHF Manual De Usuario página 47

setting, press the
Remarks：
(1) If no operation for 30 seconds, the setting will automatically exit with failure;
(2)Press the button to complete the setup and exit;
(3) If the error is found in the previous setting, the user can press the
the hour and minute setting.
(4) After the date is completely set, the system automatically determine the current date is what day in a week.
(5) Press the and
day are displayed after 2 seconds.
5. Timing setting
Press and hold the
Timing 1：When "1" light is on, enter into "timing 1 opening" setting. The "hour" light will flash, the user can press
or button to adjust the hour. After adjusting, press the
press or button to adjust the minute. If pressing the
setting, the setting way is the same " timing 1 opening" .
Timing 2: The user press the
opening" state, the setting way is the same "timing1".
Timing 3: The setting way is the same as "timing 1" and "timing 2".
If no any button pressed in 30 seconds, then automatically quit from the setting. The settings are invalid.
During the setting process, hold and press the
time setting.
6. Timing cancelling
Method 1: After timing setting successful, the user can hold and press the
3 seconds, the timing setting is cancelled. The light that represent the timing setting successful will be out.
Method 2: The user can set the timing on and off of the corresponding time period to the same time according to the
timing setting method.
7. Weekly timing setting
This timing function is circulated timing. After successful setting, the unit will run at the set time every day. The user
can set up the time of starting and closing on a daily basis according to need, and can also determine the switch time of the
specific day in a week according to need.
V.2
button to exit the setting.
button at the same time, and query the date. First the year is displayed, and the month and
button 3S to enter the timer setting, the specific method is as follows:
button again, the light "1" is out, and light "2" is on, it will enter into "timing 2
button before completing the setting to switch
button, the "minute" light will flash, the user can
button again, it will enter into "timing 1 closing"
button for 3 seconds, then the setting is done and quit from the
47
and buttons at the same time for