Tripp-Lite B126-1A1-U Manual Del Propietário página 7

Extender/Splitter Installation
1. Connect the HDMI source to the INPUT port on the B126-002 or
2. Optional for B126-004: Connect an HDMI monitor to the LOCAL
3. Connect the external power supply to the transmitter unit and plug
4. Using Cat5e/6 cable, connect one of the RJ45 output ports on the
5. Connect the B126-1A0-U to a monitor using its built-in HDMI Cable.
6. Connect the included USB Micro-B cable to the port on the
7. Repeat Steps 4-7 for each additional B126-1A0-U in the installation.
8. Turn on the power to the HDMI source and HDMI displays. The orange
9. If necessary, use the Equalization control on the B126-1A0-U to
16-12-182-9334F6.indb 7
B126-004 using a Tripp Lite P568-Series HDMI Cable.
port on the B126-004 using a Tripp Lite P568-Series HDMI Cable.
it into a Tripp Lite Surge Protector, PDU or UPS. The green LED
illuminates to indicate the unit is receiving power from the external
power supply.
transmitter unit to the RJ45 input port on the B126-1A0-U.
B126-1A0-U and a USB port on the display or a USB wall outlet. The
green LED will illuminate, indicating the unit is receiving power from
the USB Micro-B port.
RJ45 LEDs illuminate on both transmitter and receivers to indicate
the unit is receiving a signal from the source. The screen should now
be displayed on the connected monitors.
adjust the video image.
Note: An improper Equalization setting can cause the monitor to display
no picture at all. Try each Equalization setting until an acceptable picture is
displayed.
7
1/4/2017 4:40:05 PM