Mopar 82211442 Serie Instrucciones De Instalación página 5

4. Access the connectors on the bottom of the TIPM
a. Access the connectors underneath the TIPM by disengaging the
(3) locking tabs and lifting upwards.
5. Connect the hood switch wire
a. Remove the gray "B" connector from the TIPM.
** Note: Connectors are labeled on the edge of the TIPM near the connectors.
b. Remove the secondary lock from the "B" connector.
c. Insert the Violet/White hood pin switch wire into the G70 cir-
cuit, cavity 11.
Terminal Side View
Locking Tabs
"B" Connector
Secondary Lock
Cavity 11 Harness End View
5 of 9