Braun 9 Serie Manual Del Usuario página 14

Ocultar thumbs Ver también para 9 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
14 Station power socket
15 Lift button for cartridge exchange
16 Station-to-shaver contacts
17
Clean&Charge Station display
17a Level indicator
17b Status light
17c Cleaning program indicator (models 9095cc w&d/
9090cc/9075cc only)
18 Start button
19 Cleaning cartridge
Installing the Clean&Charge Station (see fig. D)
• Remove the protection foil if any from the
Clean&Charge Station display.
• Press the lift button (15) at the rear side of the
Clean&Charge Station to lift up the housing.
• Hold the cleaning cartridge (19) down on a flat,
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge from the rear side into the base
of the station until it snaps into place.
• Slowly close the housing by pushing it down until it
locks.
• Connect the station to an electrical outlet by
snapping the special cord set (11) into the power
socket (14).
Charging the shaver in the Clean&Charge
Station (see fig. D)
Insert the shaver head with the front showing and
released head lock into the cleaning station.
Important: The shaver needs to be dry and free
from any foam or soap residue!
The contacts (7) on the back of the shaver need
to align with the contacts (16) in the station. Push
the shaver in the correct position. A beep sound
confirms that the shaver sits properly in the station.
Charging will start automatically.
Cleaning the shaver (see fig. D)
When the cleaning indicator
display, insert the shaver into the Clean&Charge
Station, as described above and press the start
button (18).
The hygiene status will be analyzed and is shown
by the cleaning program indicators (17c) in the
Clean&Charge Station display (models 9095cc w&d/
9090cc/9075cc only).
If status light (17b) does not shine (Clean&Charge
Station switches to stand-by after ca. 10 minutes),
press start button twice. Otherwise cleaning will not
start. For best shaving results, we recommend
cleaning after each shave.
The cleaning process consists of several cycles, in
which cleaning fluid is flushed through the shaver
head. Depending on your Clean&Charge Station
model and/or program selected, the cleaning time
14
lights up in the shaver
takes up to 3 minutes, followed by an active drying
phase of about 40 minutes, during which a fan is
running.
Afterwards charging will resume, which is indicated
in the shaver display. When the shaver is fully charged
the display turns off.
Cleaning programs
Models 9095cc w&d/9090cc/9075cc:
short economical cleaning
normal level of cleaning
high intensive cleaning
Models 9070cc/9050cc:
One standard cleaning program is included.
Removing the shaver from the Clean&Charge
Station (see fig. E)
Hold the Clean&Charge Station with one hand and
tilt the shaver slightly to the front to release it.
Cleaning Cartridge / Replacement (see fig. F)
When the level indicator
nently red, the remaining fluid in the cartridge is
sufficient for about 3 more cycles. When the level
indicator blinks red, the cartridge needs to be
replaced (about every 3 weeks when used daily).
After having pressed the lift button (15) to open the
housing, wait for a few seconds before removing
the used cartridge to avoid any dripping. Before
discarding the used cartridge, make sure to close
the openings using the lid of the new cartridge,
since the used cartridge will contain contaminated
cleaning solution.
The hygienic cleaning cartridge contains denatured
ethanol (specification see cartridge), which once
opened will naturally evaporate slowly. Each cartridge,
if not used daily, should be replaced after approxi-
mately 8 weeks to ensure optimal disinfection.
The cleaning cartridge also contains lubricants for
the shaving system, which may leave residual marks
on the outer foil frame and the cleaning chamber of
the Clean&Charge Station. These marks can be
removed easily by wiping gently with a damp cloth.
Accessories
Braun recommends changing your shaver's Foil &
Cutter cassette every 18 months to maintain your
shaver's maximum performance.
Available at your dealer or Braun Service Centres:
• Foil & Cutter cassette: 90S/90B
• Cleaning cartridge Clean&Charge Station: CCR
• Braun Shaver cleaner spray
(17a) lights up perma-

Publicidad

Tabla de contenido
loading

Tabla de contenido