Frequently Asked Questions - Blaupunkt Bluebot XSMART Manual

Frequently asked Questions

Does Bluebot come with spare parts?
Yes, the box includes 2 extra bristles and an extra HEPA filter.
How do I clean the dust collection bin?
Turn off Bluebot and press the top lid labelled 'push'. Bluebot will now open, allowing you to remove
the collection bin. The top of the bin holds a small brush, which can be used to clean the HEPA filter.
Be careful: the HEPA filter must not get wet. The rest of the dust collection bin can be emptied in the
trash and (optionally) rinsed with water. Let the collection bin dry completely before returning it to Bluebot.
What are the di erences between the two included cleaning components?
The standard cleaning component with the rubber edge is used for general vacuum cleaning and should be used in
most cases. The component containing bristles has been optimized for cleaning carpets and more excessive dirt.
How do I use the magnetic tape?
This strip is a so-called surface limiter. It can be used to prevent Bluebot from going to specific areas
in your home. To use the magnetic strip before vacuuming, place the magnetic strip (flat side down)
on the floor to block the area: the robot detects the stripes and avoids the surface. With this you can
protect something valuable, keep Bluebot within a defined area or e.g. prevent Bluebot from driving up your carpet.
How do I use the water tank and mop?
Attach the mop using the velcro strip to the bottom of the water tank. Fill the water tank with
water and a small amount of cleaning product. Make sure the rubber cap is sealed completely.
Flip Bluebot over and attach the water tank by fitting the two small and two large pins in the
robot. Turn Bluebot back on its wheels and turn it on. The water from the water tank will spread
throughout the mop automatically.
How can I x the docking station onto the wall?
The backside of the docking station contains adhesive tape. You can chose if you want to attach the docking station or
not. For optimum stability of the docking station its recommended to fix it onto the wall. If you want to attach the
docking station to a fixed location, please peel off the protection film at the back and press the docking station onto the
wall. The wall or surface must be hard, smooth and clean without dust. For example, tile, aluminium, wood or a glass
surface. Otherwise it might result in less good fixing onto the wall. The adhesive tape is removable and can be reused.