Whirlpool 260 Guía De Referencia Rápida página 21

•
Remove the upper hinge with the
help of a toll to release the
Freezer door.
•
Remove the lower finishing plate
pulling it forwards and pressing
the two tongues located in the
upper part of the finishing plate.
•
Remove the double washer
located on the right-hand side
to later place the hinge in this
position.
•
Remove the lower hinge and
place it on the right-hand side.
Place the double washer
(previously positioned on the
right-hand side) on the left-hand
side.
•
Replace the lower finishing plate,
pressing it against the cabinet
until you observe adequate
fitting on the two plastic supports
of the cabinet.
•
Go back to the upper part, and
replace the control panel support
(that was mounted on the right-
hand side) on the left-hand side.
18