Light Bulb - Whirlpool 260 Guía De Referencia Rápida

•
Use a soft cloth or sponge soaked
in water with mild
detergent/soap. Rinse well and
dry with a clean, dry cloth.
•
To clean the outside back part of
the product, use a vacuum
cleaner of duster only.
•
If necessary, remove the lower
finishing plate, press the two
points indicated, and pull it
frontwards.
Lower finishing plate
•
To replace it, fit the lower
finishing plate into the clamps at
the lower front part of the
Freezer and press it.
•
After cleaning, connect the plug
to the wall outlet.
If necessary, set the Freezing
Control to the position desired.
Clamps

LIGHT BULB

In case the light bulb fails to work,
replace it according to the steps
below:
•
Unplug the product.
•
With the help of a screwdriver
open the transparent cover of the
light bulb compartment.
•
Unscrew the light bulb and
substitute it by a new one of the
same characteristics, 15 Watts,
that you will find at an
Authorized Service Shop.
Important
•
Light bulbs with power
higher than 15 Watts may
damage your Freezer.
•
Close the cover by pressing it
slightly.
25