Pairing - Nikon WT-2 Manual De Referencia

Pairing

Once wireless network settings have been adjusted, the camera and com-
puter must be "paired" before they can communicate in PTP / IP mode for the
fi rst time. "Pairing" allows the computer to control the camera by establish-
ing permissions between the two devices.
1
Turn the camera on.
2
Select PTP / IP for the Wireless LAN > Mode op-
tion in the camera setup menu (
3
Select On for Wireless LAN > Wireless LAN sys-
tem ( 24).
4
Confi rm that "Now in PTP / IP mode / Waiting for
connection" is displayed in the top level of the
wireless LAN menu. For information on what to
do if an error is displayed, see "Troubleshooting"
( 50).
5
Press the camera
at right will be displayed, with the camera name
in blue ( 36).
Pairing
The camera connection list (
that attempting to control the camera simultaneously from multiple computers may
produce unexpected results;
deleted from the list to make room for additional pairings.
24).
button. The message shown
36) can store the names of up to ten computers (note
21). When the connection list is full, computers can be
17