Sony PlayStation 2 SCPH-79010 Manual De Instrucciones página 87

DNR (Digital Noise Reduction)
You can use this setting to help reduce roughness in the on-screen image
and produce a cleaner picture.
Off DNR is not used.
DNR1 Increases picture quality
DNR2 Increases picture quality (maximum)
Notes
• "DNR2" is more effective for reducing image roughness than "DNR1", but in some
cases an afterimage may appear. If this occurs, select "Off".
• The DNR function may produce limited results on some DVDs.
• When you set "Progressive" to "On", "DNR" is automatically turned off and cannot
be turned on.
Outline Sharpening
You can sharpen or soften the outline of the on-screen image. The higher
the value, the sharper the outline. Normally, select "0".
• -2 • -1
Note
Depending on the DVD, Outline Sharpening may produce limited results.
Display
During playback, you can display playback status information in the top
right corner of the screen for a few seconds.
On Playback status information is displayed for a few seconds.
Off Playback status information is not displayed.
• 0 • +1 • +2
Progressive
You can display an image in which the picture updates all the lines in one
pass. In most cases, this results in a clearer, flicker-free image. This feature
is available only if your TV, AV cable* and software support progressive
scan (480p).
* The component AV cable (sold separately) is compatible with progressive scan.
On Select this option when the console is connected to a TV that supports
progressive scan (480p).
Off Select this option when the console is connected to a standard TV.
Notes
• If picture quality is reduced or no image is displayed, set "Progressive" to "Off"
when the console is connected to a TV without the necessary equipment. If you
accidentally set this option to "On" for such a TV, picture quality may be reduced
or the picture may not be displayed. To clear the setting, follow these steps:
1 Check that you have a DVD in the console.
2 Press the _/1/RESET button on the console front.
Then press and hold down the START button of the analog controller
(DUALSHOCK 2) in controller port 1 until the DVD picture is displayed.
®
The "Progressive" setting is returned to "Off", allowing the DVD-Video to
be displayed as normal. You can also cancel this setting using the "Clear
Progressive Setting" ( page 97) option in the Version Information
screen.
• DVDs can contain video-based and film-based material, which use different frame
rates. When playing video-based material using progressive scan, some images
may appear unnatural. If this occurs, set "Progressive" to "Off" and view in
standard interlace mode.
• When you set "Progressive" to "On", "TV Type" (
to "16:9".
• DVD-RW disc (VR mode) content can only be viewed in standard interlace format.
The "Progressive" option is not available when playing such content.
US
page 86) is automatically set
Adjusting DVD player settings 87