Add-On Unit Assembly - Gladiator Garageworks CADET Serie Instrucciones De Ensamblaje

4. Press the beam rivets to the bottom of the keyhole slots making
sure they are fully seated in the slots to lock the pieces together.
P2
5. Check that all Z beams are assembled in the upright position as
shown in.
Assemble Shelf Frame
1. Insert the rivets of one short Z beam (P3) into the keyhole slots at
each end at the desired location for the shelf.
2. Press the beam rivets to the bottom of the keyhole slots making
sure they are fully seated in the slots to lock the pieces together.
3. Insert the rivets of one long Z beam (P2) into the keyhole slots on
each side aligning with short Z beam locations to complete the
shelf frame.
4. Press the beam rivets to the bottom of the keyhole slots making
sure they are fully seated in the slots to lock the pieces together.
P2
P3
5. Check that all Z beams are assembled in the upright position.
10
P3
P3
P3
P2
P2
6. Turn the shelf frame over and insert the post caps (P7) into the
exposed end of each upright post.
7. Place shelf frame in the upright position.

Add-On Unit Assembly

6-Shelf Unit
1. To begin assembly of the 6-shelf unit, complete the steps in
"Bottom Frame Assembly" and "Complete Frame Assembly"
sections of "Assembly Instructions—Shelf" section.
2. Then go to "Join Frames" in this section to complete assembly of
the 6-shelf unit.
5-Shelf Unit
NOTE: P1 or P5 upright posts may be used to assemble the
workbench add-on unit.
1. Insert the rivets of the short Z beam (P3) into the top keyhole
slots of 2 upright posts (P1 or P5).
2. Insert the rivets of another short Z beam into the 7
keyhole slots from the bottom of the upright posts.
3. Press the beam rivets to the bottom of the keyhole slots making
sure they are fully seated in the slots to lock the pieces together.
P3
P3
th and 8
P1
or
P5
P1
or
P5
th
8
th
7
th