Complete Workbench Assembly - Gladiator Garageworks CADET Serie Instrucciones De Ensamblaje

4. Repeat steps 1 through 3 for the second end frame assembly.
5. Insert the rivets of one long Z beam (P2) into the top keyhole
slots on each side of the add-on unit assembly.
6. Insert the rivets of another long Z beam (P2) into the seventh and
eighth keyhole slots from the bottom of the upright posts (P1 or
P5) aligning with short Z beams to complete the shelf frame.
P2
7. Press the beam rivets to the bottom of the keyhole slots making
sure they are fully seated in the slots to lock the pieces together.
8. Turn the add-on unit over and insert the post caps (P7) into the
exposed end of each upright post.
9. Place add-on unit in the upright position.
Join Frames
1. Align the center upright posts.
2. Align the indents on the post clip (P8) with 2 keyhole slots on the
back center upright posts. Slide post clip (P8) onto upright posts
securing the 2 center upright posts together.
P2
NOTE: Upright post (P1) aligned with upright post (P5) is shown.
3. Repeat steps 1 and 2 for the front upright posts.

Complete Workbench Assembly

1. Place a laminated shelf deck (P4) on top of the Z beams (P2 and
P3).
NOTE: 5-shelf unit shown. Follow the instructions for the 6-shelf unit
also.
P4
P4
P4
2. Insert the post caps (P7) into the top of the upright posts.
P2
NOTE: Periodically inspect the unit to ensure that all Z beams are
seated properly and firmly connected to the upright posts.
P8
P4
P4
P4
P7
P3
P1
or
P5
11