Device Overview; Bottom View; Back View - Samoa U-dat Power + Guía De Servicio Técnico Y Recambio

EN
INTRODUCTION
!
WARNING!: This unit is intended for professional use.
WARNING!: The wrong connection between two U·dat units
!
may cause irreparable damage to the equipment. Consult the
section "Connection to another U·dat unit" to avoid damage.

DEVICE OVERVIEW

FRONT VIEW
Nº ITEM
1 Touch screen
2 Power button
3 Function buttons
4 RFID reader
5 Keyboard

BOTTOM VIEW

Nº ITEM
1 By-pass keyswitch
2 BUS OUT
3 BUS IN
4 RS-232 port
5 USB port
6 iButton reader
®
7 IEC power socket

BACK VIEW

Nº ITEM
Technical specifications
1
label
Holes for mount
2
bracket
Holes for flush
3
installation in forniture
2
838 847 R. 03/19
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
DESCRIPTION
Shows and receives data
Hold pressed to power off/on the unit
Allow quick access to screen menus
RFID reading area
Keyboard for data entry
DESCRIPTION
Allows the activation of by-pass mode
CAN BUS out connection
CAN BUS in connection
Allows peripheral devices connections
Allows either peripheral connections or
device upgrade
Allows identification through iButton
Power connector
DESCRIPTION
Main technical specifications of the
equipment
Self-tapping holes for assembly and
compatible with VESA 100 standard
Holes which allow the equipment
installation in workshop forniture
• This unit is intended to be part of a fluid monitoring system and allow
fluid dispensing, transactions review and stock consultation.
• Only use the unit for the purposes for which it is intended.
• This unit has not been approved for use in commercial transactions.
• Do not alter or modify the unit.
Fig. 1
1
key
®
Fig. 2
3
Fig. 3
2 3 4 5
7
1
1
2
3
4
5
6
2