Power Supply Connection - Samoa U-dat Power + Guía De Servicio Técnico Y Recambio

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
DEVICE FIXATION
The U·dat fixation to the elements of the installation can be done through
the 4 VESA 100 holes placed in the back of the case (1).
The attachment holes (2) are used in case of equipment flush
installation.
2
Fig. 4
CONNECTION TO ANOTHER U·dat UNIT
WARNING!: Never connect two U·dat units through the CAN
!
BUS out ports, it can result in serius damage to the device.
To connect several U·dat units to each other, loosen the screws (1) and
remove the cover (2) to acess the equipment connection panel. It is
mandatory to connect always the CAN BUS OUT connection (3) to the
CAN BUS IN connection of the other device (4). Two units should never
be connected through the BUS OUT connections, it can cause
irreparable damage to the device.
Fig. 7
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
260 mm (10.2")
A
4
A
A

POWER SUPPLY CONNECTION

The U·dat can be powered by alternate current both at 115 V and 230
V. The connection is done by means of the IEC C13 (3) connector
supplied with the device.
To connect the power supply loosen the screws (4) and remove the
cover (5).
1
Fig. 5
3
1
3
B
3
B
B
R. 03/19 838 847
EN
4
5
2
Fig. 6
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

U-dat383 000

Tabla de contenido