KENMORE ELITE 665.1473 Serie Manual De Uso Y Cuidado página 8

8. Using 2 - #8 - 18 x ¹ ₂" mounting screws (provided), fasten
the retaining brackets to the countertop with the mounting
screws.
Countertop mounting
A
B
C
A. Countertop
B. Retaining bracket
C. Mounting screw (provided)
NOTE: If retaining brackets cannot be attached to the
underside of countertop, attach mounting clips (provided) to
retaining brackets. Fasten compactor to kitchen cabinet
face with mounting screws through the mounting clips.
Cabinet-face mounting
A
B
A. Mounting clip (provided)
B. Kitchen cabinet
C. Retaining bracket
D. Mounting screw (provided)
8
9. Grasp sides of compactor drawer and place bottom of
drawer into tracks. Lift at the handle so drawer will go over
drawer stops. Close drawer. Check to see whether drawer
opens freely. If the toe plate rubs against floor, see
"Adjusting the Toe Plate" for further instructions.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance
may be changed as follows:
1. Mark on each side of the toe plate the amount of toe plate
that rubs the floor covering.
2. Remove the drawer from the unit. See Step 3 in the
"Unpacking" section.
3. Use a ruler and a pencil or chalk to draw a line between the
marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering, repeat
steps 1-4.
C
D