Wurth Master EB 10-A Traducción Del Manual Original página 9

OBJ_BUCH-1120-001.book Page 9 Monday, February 8, 2010 10:07 AM
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious
injury.
❏ See data sheet for further safety warnings
and instructions.
❏ Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
❏ Always wait until the machine has come to
a complete stop before placing it down.
The tool insert can jam and lead to loss of control
over the power tool.
❏ Do not open the battery. Danger of short-
circuiting.
Intended Use
The power tool is intended for cutting sheet metals
without loss due to metal chips. It is suitable for
curved and straight cuts.
For damage caused by usage other than intended,
the user is responsible.
Product Features
While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
The numbering of the product features refers to the
illustration of the power tool on the graphics page.
1 Battery unlocking button
2 Battery
3 Button for charge-control indicator
4 Battery charge-control indicator
5 On/Off switch
6 Chip deflector
7 Allen key
8 Fastening screw for upper cutter
9 Upper cutter
10 Bottom cutter
11 Adjustment screw, bottom cutter
12 Fastening screw for bottom cutter
8.2.10
For Your Safety
Protect the battery against heat,
e. g., against continuous intense
sunlight, fire, water, and moisture.
Danger of explosion.
❏ In case of damage and improper use of
the battery, vapours may be emitted. Pro-
vide for fresh air and seek medical help in
case of complaints. The vapours can irritate
the respiratory system.
❏ When the battery is defective, liquid can
escape and come into contact with adja-
cent components. Check any parLts con-
cerned. Clean such parts or replace them, if
required.
❏ Use the battery only in conjunction with
your Würth power tool. This measure alone
protects the battery against dangerous overload.
❏ Use only original Würth accessories.
Tool Specifications
Cordless Sheet
Metal Shears
Art. No.
Rated voltage
Stroke rate at no load
n
0
Max. steel sheet cutting
capacity*
Smallest curve radius
Weight according to
EPTA-Procedure
01/2003
2
* to 400 N/mm with reference to steel sheet
EB 10-A
0700 272 X
V= 10.8
-1
min 3600
mm 1.3
mm 15
kg 1.4
English–9