Intended Use; Assembly And Starting; Mains Connection; Technical Data - EINHELL BT-AC 80 Manual De Instrucciones Original

Anleitung_BT_AC_80_SPK7:_
GB
Wall mount compressor
Wall bracket
Dowel (2x)
Washer (2x)
Screw (2x)
Original Operating Instructions

4. Intended use

The compressor is designed to generate compressed
air for compressed air driven tools.
The equipment may only be used for the tasks it is
designed to handle. Any other use is deemed to be a
case of misuse. The user/operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data

Mains connection

Motor rating kW
Compressor speed min -1
Operating pressure bar
Theoretical suction rate l/min.
Sound power level L WA in dB
Protection type
Weight of the unit in kg
Protection class
6. Notes on installing
Check the equipment for damage which may
have occurred in transit. Report any damage
immediately to the transport company, through
whom the compressor was supplied.
Install the compressor in the vicinity of the point of
consumption.
Avoid long air lines and supply lines (extension
cables).
Make sure that the intake air is dry and dustfree.
Do not install the compressor in a damp or wet
room.
The compressor may only be used in suitable
14
25.06.2010 8:32 Uhr Seite 14
rooms (with good ventilation and an ambient
temperature from +5 °C to 40 °C). There must be
no dust, acids, vapors, explosive gases or
inflammable gases in the room.
The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor in
areas where work is conducted with sprayed
water.

7. Assembly and starting

Important.
You must fully assemble the appliance before
using it for the first time.
7.1. Mains connection
Before you use the machine, make sure that the
mains voltage complies with the specifications on the
rating plate. Long supply cables, extensions, cable
reels etc. cause a drop in voltage and can impede
motor start-up. In the case of low temperatures below
+5°C, motor start-up is jeopardized as a result of
stiffness.
7.2 On/Off switch (4)
To switch on the equipment set the On/Off switch (4)
to position 1.
Move the On/Off switch (4) to position 0 to switch off
230 V ~ 50 Hz
the equipment.
1
2300
7.3 Compressed air hose with quick-lock
max. 8
coupling (3)
120
Connecting:
95
Insert the nipple of the air tool into the quick-lock
IP20
coupling, the sleeve will spring forward automatically.
5,2
II / ®
Disconnecting:
Pull back the sleeve and remove the tool. Important.
When releasing the quick-lock coupling, be sure
to hold the coupling piece to protect yourself
against injury from the rebounding hose.
7.4 Wall bracket (Fig. 3,4)
Ensure that the wall to which you want to attach
the wall bracket is vertical and sufficiently solid
and durable to hold the weight of the equipment.
Do not hang heavy loads on the wall bracket
other than the equipment itself.
Select a place for mounting the wall bracket that
allows the cable to be connected to the power
plug.
Brickwork: Before drilling ensure that no water,
telephone or power lines run through the wall in