Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL BT-AC 80 Manual De Instrucciones Original

Anleitung_BT_AC_80_SPK7:_
the place you wish to drill. To do so, use only
suitable detection devices or contact an expert.
Drill two holes for the dowels (7) in vertical
position and parallel to each other. Ensure that
the drill holes have the required depth and
diameter. Press the dowels (7) into the holes until
they no longer project out of the holes. Fasten the
wall bracket to the wall with the screws (9) and
the washers (8).
Wood: If you want to attach the wall bracket to a
wooden wall use the screws (9) and the washers
(8).
Check regularly that the wall bracket is securely
fastened to the wall.
8. Cleaning, maintenance and ordering
of spare parts
Important.
Pull out the power plug before doing any
cleaning and maintenance work on the
appliance.
Important.
Wait until the compressor has completely cooled
down. Risk of burns!
Important.
Always depressurize the equipment before
carrying out any cleaning and maintenance
work.
8.1 Cleaning
Keep the safety devices free of dirt and dust as
far as possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at low
pressure.
We recommend that you clean the equipment
immediately after you use it.
Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the equipment. Ensure that no
water can get into the interior of the equipment.
You must disconnect the hose and any spraying
tools from the compressor before cleaning. Do
not clean the compressor with water, solvents or
the like.
25.06.2010 8:32 Uhr Seite 15
8.2 Storage
Important.
Pull the mains plug out of the socket and ventilate the
appliance and all connected pneumatic tools. Switch
off the compressor and make sure that it is secured in
such a way that it cannot be started up again by any
unauthorized person.
Important.
Store the compressor only in a dry location
which is not accessible to unauthorized persons.
8.3 Servicing
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Spare part number of the required spare part
For our latest prices and information please go to
www.ISC-GmbH.info
9. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

10. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
compressor and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
GB
15