Troubleshooting - Black and Decker FireStorm FS6000JSL Manual De Instrucciones

90501323 FS6000JSL
ADJUSTING THE LASER SIDE TO SIDE (FIG. F)
NOTE: Laser is intended to be a cutting aid and does not guarantee a precise cut.
Use laser adjustment screw (22) to align laser line with saw blade if needed.
WARNING: Laceration Hazard: DO NOT adjust the laser when the jig saw is
plugged in.
WARNING: Laser circuit will reduce output visibility (power) of laser when overheated.
Laser may be not visible when saw is overloaded for prolonged period of time. Laser
visibility (power) will gradually return back to normal when tool cools down even if the tool
is unplugged.
WARNING: Do not leave overheated laser ON unattended. Make sure the switch is in
the OFF position as shown in the inset of figure D. Remove the batteries to cut power to
the laser.
Hints for Optimum Use
GENERAL
- Use a high speed for wood, a medium speed for aluminum and PVC and a low speed
for metals other than aluminum.
SAWING LAMINATES
As the saw blade cuts on the upward stroke, splintering may occur on the surface closest
to the shoe plate.
- Use a fine-tooth saw blade.
- Saw from the back surface of the workpiece.
- To minimize splintering, clamp a piece of scrap wood or hardboard to both sides of
the workpiece and saw through this sandwich.
SAWING METAL
- Be aware that sawing metal takes much more time than sawing wood.
- Use a saw blade suitable for sawing metal.
- When cutting thin metal, clamp a piece of scrap wood to the back surface of the
workpiece and cut through this sandwich.
- Spread a film of oil along the intended line of cut.
Problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
4/5/06 11:06 AM Page 9

TROUBLESHOOTING

Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
9
Possible Solution
• Plug tool into a working
outlet.
• Replace circuit fuse.
(If the product repeatedly
causes the circuit
fuse to blow, discontinue
use immediately and
have it serviced at a Black
& Decker service center or
authorized servicer.)
• Reset circuit breaker.
(If the product repeatedly
causes the circuit breaker
to trip, discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
• Have cord or switch
replaced at Black &
Decker Service Center or
Authorized Servicer