Troubleshooting - Black and Decker BDCR20 Manual De Instrucciones

PROBLEM
• Tool will not turn on.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
• Unit shuts off abruptly.
For assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BLACK+DECKER help line at 1-800-544-6986.
faster and put less strain on the motor while
cutting.
• When cutting, always ensure that the shoe is
firmly against the workpiece. This will improve
operator control and minimize vibration.
• For longer blade life, use bi-metal blades.
These utilize a carbon steel back welded to
high speed steel teeth making the blade more
flexible and less prone to breaking.
MAINTENANCE
WARNING:
REMOVE BATTERY FROM
SAW WHEN PERFORMING ANY CLEANING
OR OTHER MAINTENANCE. WHEN
SERVICING USE ONLY IDENTICAL
REPLACEMENT PARTS.
• Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to various
types of commercial solvents and may be
damaged by their use. Use only mild soap and
damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any
part of the tool into a liquid.
• When electric tools are used on fiberglass
boats, sports cars, drywall etc.,they are
subject to accelerated wear and possible
premature failure, as the fiberglass chips and
grindings and drywall dust are highly abrasive
to bearings, brushes, commutator, etc. During
any use on fiberglass or drywall it is extremely
important that the tool be cleaned frequently
by blowing with an air jet.
LUBRICATION
Your tool was properly lubricated before leaving

TROUBLESHOOTING

POSSIBLE CAUSE
• Battery pack not installed properly.
• Battery pack not charged.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( To
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
9
POSSIBLE SOLUTION
• Check battery pack
installation.
• Check battery pack
charging requirements.
charger until LED illuminates.
• Plug charger into a
working outlet. Refer to
"Important Charging Notes"
for more details.
• Move charger and battery
pack to a surrounding air
temperature of above
40 degrees F (4,5°C) or
below 105 degrees F
(+40,5°C).
• Allow battery pack to cool
down.
• Place on charger and
allow to charge.
the factory. Once every year take or send your
tool to a BLACK+DECKER service center,
or authorized service station, for a complete
cleaning, inspection and lubrication. Tools
"out of service" for long periods should be
relubricated before being put back to work.
ACCESSORIES
Your reciprocating saw will accept up to a 12
inch long blade. Always use the shortest blade
suitable for your project. Longer blades are
more likely to be bent or damaged during
use. During operation, some longer blades
may vibrate or shake if the saw is not kept in
contact with the workpiece.
WARNING: S
than those offered by BLACK+DECKER, have
not been tested with this product, use of
such accessories with this tool could be
hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories
should be used with this product.
A complete line of accessories is available from
your BLACK+DECKER Factory Service Center
or a BLACK+DECKER Authorized Warranty
Service Center. Please visit our Web Site www.
blackanddecker.com for a catalog or for the
name of your nearest supplier.
ACCESSORIES
WARNING:
The use of any accessory
not recommended for use with this tool
could be hazardous.
Recommended accessories for use with
your tool are available from your local
ince accessories, other