Position The Appliance - Qilive Q.6852 Manual De Instrucciones

How to Connect the Safety Supply Hose
1. Pull the safety supply hoses completely out from the storage compartment located
at the rear of the dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with a ¾" thread.
3. Turn water on fully before starting the dishwasher.
How to Disconnect the Safety Supply Hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
5.3. DRAIN HOSE CONNECTIONS
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run
into the sink, making sure to avoid bending or crimping it. The height of the drain pipe
must be less than 1000 mm. To avoid backflow, the free end of the hose must not be
immersed in water.
Warning! Securely fix the drain hose in either position 1 or position 2, as shown in
Figure D.
How to Drain Excess Water from Hoses
If the sink is higher than 1000 mm from the floor, the excess water in hoses cannot be
drained directly into the sink. It will be necessary to drain excess water from hoses into
a bowl or suitable container that is held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water
leaks. Ensure that the water drain hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose. The hose
extension must not be longer than 4 meters. A longer hose extension could reduce the
dishwasher cleaning effect.
Syphon Connection
The waste connection must be at a height of less than 1000mm from the bottom of the
dishwasher floor. The water drain hose should be fixed in place.

5.4. POSITION THE APPLIANCE

Free-Standing Installation (See
■ Fitting Between Existing Cabinets
The height of the dishwasher is 845 mm. The dishwasher has been designed to allow
the machine to be fitted between existing cabinets of the same height in modern, fitted
kitchens. The feet can be adjusted so that the correct height is reached.
The laminated top of the appliance does not require any particular care as it is heat-
proof, scratch-proof, and stain-proof.
Fitting Underneath an Existing Worktop
■
In many modern, fitted kitchens there is a single worktop under which cabinets and
electrical appliances are fit. In this case, remove the worktop of the dishwasher by
unscrewing the screws under the rear edge of the top (a), see
Figure E)
19
Figure E.
EN