Position The Appliance; Use; Loading The Salt Into The Softener - Qilive Q.6598 Manual De Instrucciones

Drain excess water from hoses: If the sink is
■
water in hoses cannot be drained directly into the sink. It will be necessary to drain excess
water from hoses into a bowl or suitable container that is held outside and lower than the sink.
■ Water outlet: Connect the water drain hose. The drain hose must be correctly fitted to avoid
water leaks. Ensure that the water drain hose is not kinked or squashed.
Extension hose: If you need a drain hose extension, make sure to use a similar drain hose.
■
It must be no longer than
reduced.
Syphon connection: The waste connection must be at a height less than
■
bottom of the dish.

5.4. Position the appliance

Free standing
■ Position the appliance in the desired location. The back should rest against the wall behind
it, and the sides, along the adjacent cabinets or walls. The appliance is equipped with water
supply and drain hoses that can be positioned either to the right or the left sides to facilitate
proper installation.
■ Levelling the appliance: Once the appliance is positioned for levelling, the height of the
appliance may be altered via adjustment of the screwing level of the feet. The appliance
should not be inclined by more than 2° (
Fitting between existing cabinets
The height of the appliance
between existing cabinets of the same height in modern fitted kitchens. The feet can be adjusted so
that the correct height is reached (
Underneath existing work top
In most modern fitted kitchens there is only one single work top under which cabinets and electrical
appliances are fitted. In this case remove the work top of the appliance by unscrewing the screws
under the rear edge of the top (1). After removing the work top, the screws must be screwed again
under the rear edge of the top (2) (
■ Tension adjustment of the door spring: If an anaesthetic wooden panel will be installed, you
will have to adjust the door spring tension.
– The door springs are set at the factory to the proper tension for the outer door. Rotate the
adjusting screw to drive the adjustor to strain or relax the steel cable (
– Door spring tension is correct when the door remains horizontal in the fully opened position,
yet rises to a close with the slight lift of a finger.
■ Levelling the appliance: The appliance must be level for proper dish rack operation and
wash performance.
– Place a spirit level on door and rack track inside the tub as shown to check that the appliance
is level. Level the appliance by adjusting the
Notes:
■
■

6. USE

6.1. Loading the salt into the softener

■ Only use salt specifically designed for dishwashers use! Every other type of
salt not specifically designed for dishwasher use, especially table salt, will damage
the water softener. In case of damages caused by the use of unsuitable salt the
manufacturer does not give any warranty nor is liable for any damages caused.
■ Only fill with salt before running a cycle. This will prevent any grains of salt or
salty water, which may have been spilled, remaining on the bottom of the appliance
for any period of time, which may cause corrosion.
4 metres; otherwise the cleaning effect of the appliance could be
(845 mm) has been designed in order to allow the appliance to be fitted
Fig. F).
Fig. G).
When levelling, do not to let the appliance tip over.
The maximum adjustment height of the feet is
1000 mm higher from the floor, the excess
Fig. E).
3 levelling legs individually (
50
18
1000 mm from the
Fig. H).
Fig. I).
mm.