Connect The Hardware - Zyxel NWA3550 Guia De Inicio Rapido

1 Connect the Hardware

1 Use an Ethernet cable to connect the Ethernet port (opposite the power socket) on the
included MS-POE-IJ power injector (A in the figure) to the NWA3550's Ethernet port.
2 Use an Ethernet cable to connect the other Ethernet port (next to the power socket) to
a computer for initial configuration.
3 Connect the power injector to a proper power source using the included power cord.
The NWA3550 receives it's power from the power injector using PoE (Power over
Ethernet).
4 After you have completed the initial configuration, connect the Ethernet port (next to the
power socket) of the power injector to an Ethernet jack with network access (for
example, a broadband modem or router).
1.1 Power Injector Light
• The LED (light) on the power injector shines green steadily when the power is connected.
If the LED does not turn on, check your connections and inspect the cables
for damage. If the LED is still off, contact your vendor.
ENGLISH
3