Operation; Using The Temperature Mode (Default Mode Whenever The Machine Is Switched On); Using Thetime Mode - Timken VHIN 10 Manual Del Usuario

7.
There are two modes of heating:
Temperature Mode:
• Used for controlled heating up to the
desired temperature.
• Used when you wish to keep the work
piece at the desired temperature for up to
15 minutes.
Using the Temperature Mode (Default mode whenever the machine is
switched on)
• Set up the work piece and probe according to the instructions in sections
5 & 6.
• Switch the machine on.The display will show 100c (or 100F). Enter the desired
temperature to which the work piece will be heated up to using the '▲' or '▼'
key (by pressing the temperature mode key (· ) you can choose between
steps of 1º or 10º - this is the same whether working in C or F).
• Press the 'START' key. Heating starts and a soft buzzing sound will be
heard.
• The current temperature of the work piece appears on the display. When
the desired temperature has been reached, the display starts to blink and
a loud beeping is emitted. Unless you press the 'STOP' key, the heat-
retention function will keep the bearing at that temperature for 5 minutes.
The machine resumes heating after a temperature drop of 3º (C or F).When
the set temperature is reached once more the induction heater emits a
loud beep. Press the 'STOP' key to switch off the machine.
• The heating process or the heat-retention function can be interrupted at
any time by pressing the 'STOP' key.

Using theTime Mode

• Set up the work piece and temperature probe according to the instruc-
tions in sections 5 & 6 (the temperature probe is only necessary if you
want to check the temperature).
noticeheaterGB.indd 15

Operation

Time Mode:
• Suitable for batch production. If the
time taken to heat the work piece to the
desired temperature is known.
• Emergency use if the temperature probe
is lost or defective. The temperature
of the work piece should be checked
using an external thermometer.
15
GB
17/10/06 15:17:04