Test Light Instructions - Petsafe Wireless Pet Containment System Guía Para El Uso

Test Light Instructions

Important: Remove Test Light before placing Receiver Collar
on your pet.
1. Set Receiver Collar to Static Correction Level 6.
2. Remove the battery.
3. Loosen the Contact Points with pliers.
4. Bend the leads around the base of each Contact Point.
5. Hand tighten the Contact Points,
making sure that the leads stay in
contact with the bases of the Con-
tact Points.
6. Replace the battery.
7. The Test Light will flash in the
Boundary Zone if the Receiver Col-
lar is working properly.
8. Remove the Test Light and tighten
the Contact Points with pliers one-
half turn beyond finger tight.
Save the Test Light for future testing.
Note: If the Test Light does not flash, install a new battery and re-test. If Test
Light still does not flash, contact the Customer Care Center at 1-800-732-2677.
www.petsafe.net 13