Uline H-959 Manual De Instrucciones página 2

1. Set strap feed length: Determine the length of strap
needed. Set control for 0-6. Lengths listed in meters.
1 = 3 ft. of strap. Example: for 6 ft. of strapping, set
the control at "2". (See Figure 3)
2. Turn power ON. Allow machine to heat up 3-4
minutes. Strap won't seal if heating blade is not hot
enough.
(See Figure 3)
3. Pre-feed the strap: Press and hold the FEED button
until the desired length of strap feeds out. (See
Figure 3)
NOTE: Pre-feeding is only necessary after
installing a new strap coil or finishing a coil.
4. Strapping the package:
a. Place package on the machine against the
package guide. (See Figure 4)
b. Pass strap around package and insert the strap
end into the strap inlet to start the strapping
tensioning and heat sealing cycle. (See Figure 5)
c. Strap tensions, heat seals and cuts. Remove
package.
d. Timer resets, strap feeds out and machine is
ready for the next package.
5. Turn power OFF.
MOTOR TIMER
The timer is located on the printed circuit box (PCB Box).
If your machine runs for a long time between packages,
turn the timer down. If the machine is used more
3
2
1
5
6
PAGE 2 OF 9
OPERATION INSTRUCTIONS
4
frequently, turn the timer up so the motor isn't starting
and stopping all the time. (See Figure 6)
Figure 4
LEN GTH
RES ET
3
ON 2 FEE D
4
5
OFF
0
M MAX
Motor
Timer
REFERENCE
# DESCRIPTION
11
1 POWER SWITCH: TURNS MACHINE ON/OFF.
2 FEEDING LENGTH CONTROL: LENGTHS LISTED IN METERS.
10
RESET BUTTON: COMPLETES CYCLE AND RETURNS MACHINE
3
TO "HOME" POSITION.
9
4 STRAP FEED BUTTON: RUNS OFF ANY LENGTH OF STRAP.
7
5 PLUG: 110V
6 STRAP REEL: HOLDS STRAP COIL.
8
7 BRAKE: STOPS BAND REEL FROM OVER ROTATING.
8 STRAP GUIDE FOR BRAKE: STRAP THREADS THROUGH GUIDE.
9 STRAP BYPASS GUIDE: STRAP THREADS THROUGH GUIDE.
10 FEED GUIDE
STRAP INSERTION INLET: DETECTS LEADING EDGE OF STRAP TO
11
START TENSIONING/HEAT SEALING CYCLE.
RESET
3
2 4
ON
1
5
OFF
0 MAX
M
30
FUSE
20 40
10 50
0 60
SECS
FEED
Figure 3
Figure 5
110V/10A
220V/7A
Figure 6
0221 IH-959