Assembly; Contents Of Carton; Tools Required For Assembly - Craftsman 919.167380 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Contents of Carton

1 - Air Compressor
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Molded Foot Bumpers
2 - Screws, 1/4 x 1-1/2
1
Handle
1 - Handle Grip
2 - Screws, #10-16 x 1
Tools Required for

Assembly

1 - 9/16" socket or open end
wrench
1 - 3/8" socket
Installing Handles,
Wheels, and Molded Foot
Bumpers
do not provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
1.
Submerge handle grip into warm
soapy water to make installation
easier. Remove handle grip from
soapy water and slide onto
handle.
2.
Slide handle through holes in
compressor saddle onto tabs.
Secure with screws, one on each
side.
Compressor Saddle
Handle
Tab
N000349
ASSEMBLY
The wheels
and handle
Screw
support one side of the outfit when
installing the wheels because the
compressor will have a tendency to
tip over.
3.
Install one shoulder bolt
and one nut for each wheel.
Tighten securely. The outfit
will sit level if the wheels are
properly installed.
Nut
4.
Clean and dry underside of
air tank leg opposite wheels.
Remove the protective strip from
the adhesive backed molded
foot bumpers. Attach the foot
bumpers to the bottom of leg
on each end. Press firmly into
place.
Molded Foot Bumpers
10- ENG
It will be necessary
to brace or
Wheel
Shoulder Bolt

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido