Panasonic WV-Q116E Manual De Instrucciones página 3

Two spacer nuts are needed to use the exist-
ing anchor bolt instead.
Fall Prevention Clip
5. Attach the end of the Fall Prevention
Wire to the bracket.
5-1. Put a standard anchor nut onto
anchor bolt (2).
5-2. Remove the Fall Prevention Wire
from the Fall Prevention Clip.
5-3. Insert the anchor bolt (2) through
side "1".
5-4. Fold (manually bend the clip) side
"2" down onto side "1" (when fold-
ed properly side "1" and side "2"
should match).
5-3
5-2
Side "1"
Anchor bolts
Spacer nuts
Spacer nuts
Existing anchor bolt
5-1
Side "2"
5-4
5-6
5-5
5-5. Reattach the Fall Prevention Wire
to the matched holes of side "1"
and "2" of the Fall Prevention Clip.
5-6. Put two standard anchor nuts onto
anchor bolt (2).
5-7. Tighten the three nuts to fix the Fall
Angle Clip.
6. Connect the Fall Prevention Wire and
put the bracket into the suspended ceil-
ing through the hole.
7. Fix the camera mount bracket to the
suspended ceiling by rotating the four
ceiling panel screws clockwise.
8. Mount the bracket onto anchor bolt (1).
Anchor nut
Nuts
Clockwise
- 3 -
Ceiling panel
screws
Ceiling support