Chauvet EZrail RGBA Guía De Referencia Rápida página 3

EN
Description
Overview
AC Power
Power Linking
Fuse
Replacement
Charging the
Battery
Battery Life
Indicator
Infrared Remote
Control (IRC)
The EZrail™ RGBA is a linear RGBA fixture with a rechargeable lithium
battery. Control options include Sound-Active mode, automatic programs,
Master/Slave mode, DMX, and included Infrared Remote Control (IRC). Six
personality choices are available through 2-, 4-, 5-, 8-, 10- and 18-channel DMX
modes.
Power
Microphone
Switch
DMX In
DMX Out
Control Buttons
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 32 EZrail™ RGBA products at 120 VAC and 64 units at
230 VAC.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
The EZrail™ RGBA comes with a rechargeable lithium battery for cable-free
operation. To charge the battery, simply plug in the power cord at any time
before, during, or after operation. To charge the battery before or after operation
with all the LEDs off, leave the power switch in the Off postion. The red
indicator light for the battery turns on while the battery is charging. The green
indicator light turns on when the battery is done charging.
The battery life indicator shows the remaining amount of internal battery life
when the the menu buttons are inactive.
100%
The EZrail™ RGBA is fully compatible with the Infrared Remote Control
(IRC) from CHAUVET®. For more information on the IRC or to download
instructions, go to www.chauvetlighting.com.
Display
Battery Charged
Green Indicator Light
Battery Charging
Red Indicator Light
75%
3
EZrail™ RGBA QRG
Power In
Safety Loop
Fuse Holder
Back Panel View
50% 25%
Power Out