Operation - Delta SA180 Manual De Instrucciones

ASSEMBLING BELT SANDER TABLE
1. Disconnect machine from power
source.
2. Position the table assembly (A) Fig. 17, in position on
the belt sander frame. Place a 10mm flat washer (C)
Fig. 17, on the locking stud (B), and thread locking
stud (B) into threaded hole in casting to hold table
assembly in place, as shown.
3. Place handle (D) Fig. 18, onto locking stud and
fasten with screw (E) and spring.
4. NOTE: The locking handle (D) Fig. 18, is spring-
loaded and can be repositioned by pulling out the
handle and repositioning it on the serrated stud
located underneath the handle.
FASTENING SANDER TO SUPPORTING
SURFACE
If during operation there is any
tendency for the sander to tip over, slide or walk on
the supporting surface, the sander must be secured
to the supporting surface. Two holes are supplied in
the sander base plate for mounting.
OPERATIONAL CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING SANDER
Make sure that the switch is in the
"OFF" position before plugging cord into outlet. Do
not touch the plug's metal prongs when unplugging
or plugging in the cord.
The on/off switch (A) Fig. 21 is located on the front of the
sander To turn the machine "ON", move the switch up to
the "ON" position. To turn the machine "OFF", move the
switch (A) down to the "OFF" position.
LOCkING SWITCH IN THE "OFF" POSITION
IMPORTANT: When the machine is not in use, the
switch should be locked in the "OFF" position to
prevent unauthorized use. To lock the machine, grasp
the switch toggle (B) and pull it out of the switch (Fig. 22).
With the switch toggle (B) removed, the switch will not
operate. However, should the switch toggle be removed
while the sander is running, the machine can be turned
"OFF," but cannot be restarted without re-inserting the
switch toggle (B).
In the event of a power outage (such
as a breaker or fuse trip), always move the switch to
the "OFF" position until the main power is restored.

OPERATION

A
13
A
C
Fig. 17
D
Fig. 18
Fig. 21
Fig. 22
B
E
B