Assembly - Delta SA180 Manual De Instrucciones

For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 1-2 hours.
TOOLS NEEDED
8mm hex wrench
Phillips screw driver
ASSEMBLING BELT UNIT TO BASE
1. Place a 10mm lockwasher (D) Fig. 1, and a 10mm flat
washer (E) onto a M10x1.5x20mm hex socket head
screw (A) and insert the screw up through the hole (B)
in the base. DO NOT COMPLETELY TIGHTEN THE
TWO SCREWS (A) FIG. 2 AT THIS TIME. Thread the
screw into the tapped hole (C) in the bottom of the
belt unit, repeat this process for the remaining hole.
2. Fig. 2, illustrates the two screws (A), inserted into the
two holes in the bottom of the base.
3. Fig. 3, illustrates the belt unit (D) assembled to the
base.
ASSEMBLING DRIVE BELT AND
ADJUSTING BELT TENSION
1. Disconnect machine from power
source.
2. Assemble the drive belt (A) Fig. 4, to the two pulleys,
as shown.
3. Slide the belt sander frame assembly (B) Fig. 4,
forward until there is approximately 1/4 to 1/2 inch
deflection in the belt (A) at the center span of the
pulleys using light finger pressure.
4. Then tighten the two M10x1.5x20mm hex socket
head screws (A) Fig. 2, that fasten the belt unit to the
base.

ASSEMBLY

B
B
9
B
A
D
Fig. 1
A
Fig. 2
D
Fig. 3
A
Fig. 4
C
E