Uline H-8098 Manual De Instrucciones página 3

• Pull lid latches in an outward motion and remove
tank cover. Remove any accessories and literature
that may have been packed in the vacuum tank.
TOOL HOLDER
1. Set tank cover onto the tank. Position with back of
tank cover facing you.
2. Press tabs of tool holder into the slots on mounting
lugs, located on back of tank cover. (See Figure 2)
Figure 2
WARNING! This vacuum has parts including
switches, motors and the like that tend to
produce arcs or sparks that can cause
an explosion. Do not pick up flammable,
combustible or hot materials. Do not use
around explosive liquids or vapors, as electrical
devices produce arcs or sparks, which can
cause a fire or explosion. Do not use at filling
stations or anywhere gasoline is stored or
dispensed.
1. Refer to the filter installation and maintenance
section to make sure the correct filters are installed
for your cleaning operation.
2. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
PAGE 3 OF 24
UNPACKING
ASSEMBLY
3. Press down until tabs snap into place. Remove
tank cover from tank and refer to the set up and
operation section. (See Figure 3)
Figure 3
SETUP
3. Insert machine hose
end with locking nut
into inlet in front of the
tank. Turn locking nut
clockwise to tighten.
Do not over-tighten.
(See Figure 4)
4. Attach desired
cleaning accessory
onto accessory end
of hose.
5. Plug cord into wall outlet. Your cleaner is
ready for use.
Figure 4
0721 IH-8098