DAILY
1.
Filter – Check cartridge filter for clogs or heavy
soiling and replace if necessary. Ensure that correct
filters are being used for the task – see Filters section
of instruction manual.
2. Collection Bag – If using collection filter bag, check
to ensure that there are no rips or tears in the bag
and that the bag is not full.
3. Tank – If vacuuming up wet or damp material,
empty tank after use, as musty odors may occur if
debris is left inside.
4. Extension Cord and Plug – Check extension cord
and plug for any cuts or damage. If damaged,
replace motor housing unit.
ISSUE
Parts/accessories missing
Vacuum cleaner will not
start
Dust discharging from
exhaust
Loss of suction
Static shock
PAGE 8 OF 24
ROUTINE MAINTENANCE
TROUBLESHOOTING
POSSIBLE CAUSE(S)
1.
Packed in tank
1.
No power at receptacle
2. Defective switch
3. Defective motor
1.
Filter not installed or
installed improperly
2. Filter damaged
3. Filter clogged or dust is
too fine
4.
Filter not functional
1.
Loose hose connection
2. Filter clogged
3. Full tank
4.
Hole in hose
1.
Dry environment
2. Relative humidity of air is low
1-800-295-5510
uline.com
5. Motor – If there are unusual sounds or if poor
performance occurs, the motor should be inspected
immediately. Contact Uline Customer Service.
WEEKLY
1.
Wands/Tools – Inspect wands and tool attachments
for any damage. Replace if necessary.
2. Hose – Inspect hose for any damage and replace if
necessary.
MONTHLY
1. Cleaning – Inspect and clean all areas of vacuum,
including inside of tank.
CORRECTIVE ACTION
1. Check in tank.
1. Check for power.
2. Replace switch.
3. Replace motor.
1.
Properly install filter.
2. Replace filter.
3. Use more efficient filter.
4. Clean and replace filter.
1. Tighten hose connection.
2. Clean or replace filter.
3. Empty tank.
4. Replace hose.
1. Add moisture to air (if practical, use a
console or installed humidifier).
2. This situation is temporary and does not
affect use of vacuum cleaner.
0721 IH-8098