Wet Pickup Operation - Uline H-8098 Manual De Instrucciones

FILTER INSTALLATION AND MAINTENANCE CONTINUED
DISPOSABLE FILTER BAG
Use the disposable filter bag in conjunction with
cartridge filter for easy disposal of debris. The bag is not
required for normal dry pickup. When picking up fine
dust or powders, a high efficiency filter bag must be
used. NOTE: For dry use only.
1. Make sure cord is disconnected from the receptacle,
tank cover is removed and hose is disconnected
from tank inlet.
2. Remove inlet deflector from
deflector guide. NOTE: Hose
must be removed before inlet
deflector can be taken out.
(See Figure 8)
3. With the opening of the inlet
deflector facing the left or
right side of the filter bag, slide
filter bag collar over deflector,
matching notches of bag collar
to tabs on inlet deflector. Bag
will only fit properly one way.
(See Figure 9)
4. Slide deflector with filter bag
attached into deflector guide.
(See Figure 10)
5. Reinsert hose into inlet and tighten
locking nut. When secured in
place, expand bag and position
around inside of tank.
NOTE: When removing filter bag from tank,
remove inlet deflector from filter bag collar
and reinstall into deflector guide. Inlet
deflector should always be in place for any
type of cleaning.
WARNING! For fine dust and powders – When
vacuuming fine dust or powders of any kind
(plaster, drywall dust, cold ashes, concrete
dust, etc.), a high efficiency drywall filter
bag must be used. When vacuuming
normal household dust and debris, standard
household disposable filter bags may be used.

WET PICKUP OPERATION

1. Your vacuum can be used for wet pickup. Remove
all dirt and debris found in the tank. Remove all dry
use filters, including the filter bag, from the vacuum.
PAGE 5 OF 24
Figure 8
Figure 9
Figure 10 Figure 10
2. A clean cartridge filter may be used to pick up small
quantities of liquid. To use cartridge filter, follow the
instructions under dry pickup.
3. For vacuuming large quantities of liquid, use a foam
sleeve. A foam sleeve can be purchased from Uline. To
use the foam sleeve, follow the instructions in this section.
4. Misting in exhaust air or dripping of liquid around
tank cover may occur if filter becomes saturated
during wet pickup. If this occurs, remove filter and
allow to dry or replace with another dry filter.
5. Turn unit off immediately upon completing a wet
pickup job or when tank is full and ready to be
emptied. When tank is full, suction will drastically
reduce. Refer to automatic suction shutoff section
for more information. Raise the hose to drain any
excess liquid into the tank. Follow the instructions in
the "Emptying Liquid Waste" section.
6. Before storing vacuum cleaner or using for dry
pickup, clean and dry interior of tank and underside
of the tank cover. Clean and allow filters to dry
completely.
7. Wet pickup accessories should be washed
periodically, especially after picking up wet, sticky
liquids. This can be accomplished with a warm
solution of soap and water.
FOAM SLEEVE
1. With tank cover in an upside
down position, slide foam
sleeve down over lid cage.
(See Figure 11)
2. Place filter retainer onto top of foam sleeve. Hold
tank cover with one hand and turn handle on filter
retainer clockwise to lock filter into place.
3. To clean foam sleeve, hold tank cover and turn filter
retainer counter-clockwise to loosen and remove.
Slide foam sleeve up and off lid cage. Shake excess
debris off of foam sleeve with a rapid up and down
movement.
4. Hold foam sleeve under running water for a couple
minutes, rinsing from inside of filter. A water wash is
not always required, depending on condition of the
filter.
5. Check filter for tears. If any are found, replace with
a new filter.
Figure 11
0721 IH-8098