Front Panel; Rear Panel - TP-Link TL-SF1024 V1 Manual De Instrucciones

Chapter 2 Identifying External Components
This Chapter describes the front panel, rear panel and LED indicators of the
Switch.

2.1 Front Panel

The front panel of TL-SF1016 consists of switch model, switch LED indicators,
and 16 10/100Mbps RJ-45 ports.
Figure 2-1 TL-SF1016 Switch Front Panel sketch
The LED indicators include Power, Link/Act LED indicators, which are used for
monitoring and pre-troubleshooting of the Switch. The following section shows
the LED indicators of the Switch along with an explanation of each indicator.
Power LED: This indicator will light solid red when the Switch powers up.
If the LED is not lit, please check the power supply and connection.
Link/Act LED: The LED indicates Link/Active status. The corresponding
LED indicator will light solid green when connected to a network device.
It flashes green when data is being transmitted or received on the
working connection.
100Mbps: The corresponding port LED indicator will light solid green
when it's working on 100Mbps speed. Not lit indicates working on
10Mbps speed.
Note:
Because of the difference among the mode of switch, some switches don't
include the 100Mbps indicator, such as TL-SF1048, TL-SF1016DS, TL-
SF1024D and a few of TL-SF1016 switch.

2.2 Rear Panel

The rear panel of TL-SF1016 features a power socket and a Grounding
Terminal (marked with
Figure 2-2 TL-SF1016 Switch Rear Panel sketch
).
6