Front Panel Leds - Vess R2000 Serie Guia De Inicio Rapido

With the power supplies connected, the system can now be powered on. Again, note that if your setup includes a SAN, DAS or cascade
with Vess J2600 expansion, always power on the JBOD subsystems first.
To power on the subsystem, press the Power button on the front left bracket facing (see "Figure 21: Vess R2600 front panel components,
left side"). Observe the LEDs on the right front bracket facing (see "Figure 22: Vess R2600 front panel LED display on right side
bracket").
Figure 21: Vess R2600 front panel components, left side
Power button
OPAS LED
USB ports
Mute alarm LED
Mute alarm button

FRONT PANEL LEDS

When boot-up is finished and the Vess R2600 subsystem is functioning normally:
• Power LEDs display blue continuously.
• Global Enclosure Status, and Global RAID Status LEDs display green continuously.
• Controller Activity LED flashes blue when there is controller activity.
• System Heartbeat LED blinks blue seven times in three seconds, goes dark for six seconds, then repeats the pattern.
Figure 22: Vess R2600 front panel LED display on right side bracket
Power
Global Enclosure Status
Global RAID Status
Controller 1 Activity
Controller 2 Activity
System Heartbeat
14