Making Automatic Ip Settings; Configuring The Raid; Viewing Ip Address And Settings; Exiting The Clu - Vess R2000 Serie Guia De Inicio Rapido

1. Press the arrow keys to highlight IP Address.
2. Press the backspace key to erase the current IP Address.
3. Type the new IP Address.
4. Follow the same procedure to specify the Subnet Mask, Gateway IP Address and DNS Server IP Address.
If you do not have a DNS server, skip the DNS Server IP Address.
5. Press Ctrl-A to save these settings and move to the RAID configuration screen.

MAKING AUTOMATIC IP SETTINGS

To make Management Port and iSCSI Port settings automatically:
1. Press the arrow keys to highlight DHCP.
2. Press the spacebar to toggle to Enable.
3. Press Ctrl-A to save these settings and move to the RAID configuration screen.

CONFIGURING THE RAID

You can configure your RAID arrays and logical drives using the CLU at this time. However, those actions are described in "Task 7:
Creating Logical Drives with Web- PAM PROe". PROMISE suggests that you highlight Skip the Step and Finish and press Enter. Then
create your disk array using WebPAM PRO.

VIEWING IP ADDRESS AND SETTINGS

To view the current IP address and network settings when using DHCP:
1. In the CLU Main Menu, highlight Network Management and press Enter.
2. Highlight the Management Port or iSCSI Port you want and press Enter.
3. Highlight DHCP and press the spacebar to toggle to Disable.
The current Management or iSCSI Port settings are displayed.
4. Press the spacebar to toggle DHCP back to Enable.
5. Press Ctrl-A to save these settings and move to the RAID configuration screen.

EXITING THE CLU

In the CLU Main Menu, highlight Return to CLI and press Enter.
This completes the Management Port setup.

TASK 7: CREATING LOGICAL DRIVES WITH WEBPAM PROE

Setting up WebPAM PROe consists of the following actions:

• Logging into WebPAM PROe

• Choosing a Language
• Creating Your Logical Drives
• Logging out of WebPAM PROe
• Using WebPAM PROe over the Internet
LOGGING INTO WEBPAM PROE
1. Launch your Browser.
2. In the Browser address field, type the IP address of the Vess R2600 subsystem.
3. The initial HTTP connection is automatically redirected to a secure HTTPS connection.
Use the IP address you obtained in Task 7 (see "Task 6: Setting the IP Address". Note that the IP address shown below is only an
example. The IP address you type into your browser will be different.

INITIAL CONNECTION

• WebPAM PROe uses an HTTP connection
• Enter the Vess R2600's IP address
• Together, your entry looks like this:

SECURE CONNECTION

• WebPAM PROe uses a secure HTTP connection
• Enter the Vess R2600's IP address
Together, your entry looks like this:
http://
10.0.0.1
http://10.0.0.1
https://
10.0.0.1
https://10.0.0.1
17