Safety System; Before Use; Using The Appliance - Moulinex Frutti pro xl Manual De Instrucciones

• This product has been designed for domestic use only. Any commercial use, inappropriate
use or failure to comply with the instructions, the manufacturer accepts no responsibility
and the guarantee will not apply.
• Only use original accessories and components. The manufacturer cannot accept any
responsibility if this is not the case.
• Switch off the appliance and disconnect from the mains before changing accessories or
approaching parts that are in movement.
• Never put your fingers or any other object in the feed tube while the appliance is in
operation. Always use the pusher provided for this purpose.
• Never open the cover until the sieve (D) has ceased rotating.
• Do not remove the pulp collector (G) while the appliance is in use.
• Always unplug the appliance from the mains after use.

SAFETY SYSTEM

This appliance is fitted with a safety mechanism. To start the juice machine the cover (C)
must be properly secured by the safety clamp (H). At the end of a cycle:
1. place the On/Off switch (I) to 0
2. wait until the sieve (D) stops completely before removing the cover
3. open the safety clamp (H).

BEFORE USE

• Unpack the appliance and then place it on a flat, stable, heat-resistant work surface.
• We recommend that you wash all the removable parts (A, C, D, E, G, M) in hot soapy
water (see Cleaning and Maintenance §). Rinse and dry them carefully.
• Ensure that all packaging has been removed before starting the appliance.

USING THE APPLIANCE

• Fit the juice collector (E) onto the drive shaft (K) (see Fig. 1).
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is correctly clipped
onto the drive shaft (K). You can hear an audible click (see Fig. 1).
• Fit the cover (C) on the appliance (see Fig. 1).
• Fit the pulp collector (G) at the rear of the appliance by clipping it into the slot (see Fig. 2)
• Click the safety clamp (H) into place over the cover (C) (see Fig. 3).
• Slide the pusher (A) into the feed tube (B), aligning the groove of the pusher with the
small ridge in the feed tube.
• Position the juice jug (M) under the pouring spout (F) in front of the appliance as shown
on Fig. 4. The foam separator allows you to keep the froth into the juice collector when
you pour the juice into a glass (see Fig. 5).
• Plug in the appliance. You can use the cord storage to adjust the length of the cord (see
Fig. 6).
• Start the appliance using the On/Off switch (I).
• Select the appropriate speed (J): 2 for pineapple and carrots; 1 for all other fruits and
vegetables. The quality and quantity of juice varies greatly according to the date of
harvest and the particular variety of fruits or vegetables.
6