Dometic GROUP Waeco MagicComfort MSH300 Instrucciones De Montaje Y De Uso página 25

MagicComfort MSH300, MSH301
➤ Insulate all the trimmed ends with the insulating material.
Installing the heating element for the seat surface
➤ Insert the heating element for the seat surface between the cover fabric
and the foam core of the seat (fig. b, page 4).
➤ If anchoring grooves are present, make sure that the cut-out sections are
positioned over the anchoring grooves (fig. c, page 4) and place the
heating elements in the anchoring grooves.
➤ Fasten the heating element using double-sided adhesive tape to prevent
it sliding on the foam core.
Ensure that no creases or kinks form.
Installing the heating element for the backrest
A
NOTICE!
If the seats are equipped with side airbags, then there is a prede-
termined breaking point in the cover fabric. The seat cover must
therefore not be pulled tightly or slip out of place.
➤ Open the lower area of the backrest cover (fig. d, page 4).
➤ Push the heating element into the gap between the seat cover and the
seat cushion (fig. e, page 4).
➤ Fasten the heating element using double-sided adhesive tape to prevent
creases.
Installing the seat
➤ Reassemble the backrest and seat.
➤ Lift the seat into the vehicle.
➤ Secure the vehicle seat with the fastening screws.
EN
Installing the seat heater
25